Turning On The Appliance - Haier HDW6WH Installation Instructions Manual

Turning on the Appliance

Starting a wash cycle...
1.Make sure that the plug for the appliance is inserted into the
wall socket.
2.Make sure that the water supply is turned on to full pressure.
3.Load the dishwasher (see the section entitled, "Loading the
Dishwasher")
4.Pour in the detergent (see the section entitled, "Deter-
gent and Rinse Aid").
5.Turn the control knob located on the right of the control panel
in a clockwise direction until the number or symbol for the
cycle setting is aligned with the reference mark (see the sec-
tion entitled, "Wash Cycle Table")
6.Press the ON-OFF button, and the ON-OFF light will turn on
and, The wash cycle will begin.
Cancelling or modifying a wash cycle setting...
Please note: A cycle that is underway can only be modified if
it has only been running for a short time. Otherwise, the deter-
gent may have already been used, and the appliance may
have already drained the wash water, If this is the case, the
detergent dispenser must be refilled (see the paragraph
entitled, "Loading the Detergent").
Press the ON-OFF button, and the ON-OFF light will turn off,
Rotate the knob in the clockwise direction to the desired cycle
setting (see the section entitled, "Starting a wash cycle...").
Then, turn on the dishwasher, using the ON-OFF button.
If you forget to load some of the dishes...
The wash cycle can be interrupted by pressing the ON-OFF
button, You can then load additional dishes and turn on the
appliance again. The cycle will start where it left off.
At the end of the wash cycle...
-When the knob stops turning and is aligned with a STOP
mark, the cycle has finished, Turn off the appliance using the
ON-OFF button, turn off the water supply and open the door
of the dishwasher.
-Wait a few minutes before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and
more susceptible to breakage. They will also dry better.
Energy Saving Tips
-It is important to try and run the dishwasher when it is fully
loaded in order to save on energy. In order to prevent odors
from forming and food from caking onto the dishes, you can
run the pre-rinse cycle.
-Choose the right wash cycle: the choice of cycle depends on
the type of dishware, cookware and utensils being washed
and how dirty they are.
-Use the right amount of detergent: If you use too much
detergent, the result will not be cleaner dishes, but rather, a
greater negative impact on the environment.
GB