Table of Contents
Advertisement
3. Setup
AC Power
The COLORband Q4 IP has an auto-ranging power supply, and it can work with an input voltage range of
100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product's back panel, or refer to the product's specifications chart.
The listed current rating indicates the product's average current draw under normal conditions.
•
Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
Power Linking
The product provides power linking via the outlet located in the back of the product. See the diagram below
for further explanation.
Power Linking Diagram
Power
source
rd
3
product
You can power link up to 9 COLORband Q4 IP products on 120 VAC or up to 16 products
on 230 VAC.
Page 4 of 14
st
1
product
COLORband Q4 IP User Manual Rev. 1
Setup
nd
2
product
Additional
products
Advertisement
Table of Contents
