Table of Contents
Advertisement
Safety Notes
•
This product is not intended for permanent installation.
•
Do not submerge this product (IP65). Temporary outdoor operation is fine.
•
When using this product in an outdoor environment, use IP65- (or higher) rated power and data
cables. Secure unused power and data ports with attached IP65 covers.
•
Not for permanent outdoor installation in locations with extreme environmental conditions. This
includes, but is not limited to:
•
Exposure to marine/saline environment (within 3 miles of saltwater body of water).
•
Locations where the normal high or low temperatures exceed the temperature ranges
in this manual.
•
Locations that are prone to flooding or being buried in snow.
•
Areas where the product will be subjected to extreme radiation or caustic substances.
•
Always connect the product to a grounded circuit to avoid the risk of electrocution.
•
Avoid direct eye exposure to the light source while the product is on.
•
Make sure the power cord is not crimped or damaged.
•
Never disconnect the product from power by pulling or tugging on the cord.
•
If mounting the product overhead, always secure to a fastening device using a safety cable.
•
Make sure there are no flammable materials close to the product when operating.
•
Do not touch the product's housing when operating because it may be very hot.
•
The voltage of the outlet to which you are connecting this product must be within the range
stated on the decal or rear panel of the product.
•
Always install the product in a location with adequate ventilation, at least 20 in (50 cm) from
adjacent surfaces.
•
Never connect the product to a dimmer or rheostat.
•
Make sure to replace the fuse with another of the same type and rating.
•
Never carry the product from the power cord or any moving part. Always use the bracket.
•
The maximum ambient temperature is 104 °F (40 °C). Do not operate this product at higher
temperatures.
•
In the event of a serious operating problem, stop using the product immediately.
•
Do not open this product. It contains no user-serviceable parts.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Keep this User Manual for future use. If the product is sold to someone else, be sure that they
also receive this document.
Page 2 of 14
Before You Begin
COLORband Q4 IP User Manual Rev. 1
Advertisement
Table of Contents
