Table of Contents
Advertisement
Available languages
Available languages
SN29402200_DRX-5_BAS_En_1603XX.book 28 ページ ２０１６年３月１６日 水曜日 午後５時１３分
> Before start
> Hookup
Rear Panel
1
2 3
12
1. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV component
digital audio signals with a digital optical cable or digital coaxial cable.
2. TUNER AM/FM 75Ω terminals: The supplied antennas
are connected.
3. VIDEO IN jacks: Input the video signals from AV
components with an analog video cable.
4. USB port: A USB storage device is connected so that
music files stored in it can be played. You can also supply
power (maximum 5V/1A) to USB devices with a USB cable.
5. ETHERNET port: Connect to the network with an
Ethernet cable.
6. COMPONENT VIDEO IN jacks: Input the video signals
from AV components with a component video cable.
7. HDMI OUT jacks: Transmit video signals and audio signals with
a HDMI cable connected to a monitor such as a TV or projector.
28
> Setup
> Playback
4
5
6
7
13
14
15
16
17
8. HDMI IN jacks: Transmit video signals and audio signals
with a HDMI cable connected to an AV component.
™
9. HDBaseT
IN/OUT jack: HDMI input signals are output via
the Ethernet cable. As they are covered with a seal when
shipped, remove it when you use the ports. Do not use the
ports to connect the ETHERNET port of network device.
10.RS232 port: For connection to the home control system.
11. AC INLET: The supplied power cord is connected.
12.GND terminal: The ground wire of the turntable is connected.
13.AUDIO IN jacks: Input TV or AV component audio
signals with an analog audio cable.
14.SPEAKERS terminals: Connect speakers with speaker
cables. You can connect the multichannel speakers for the
main room and the speakers for a separate room (ZONE 2).
(North American models are compatible with banana plugs.)
> Part Names
8
9
10
18
19
20
15. ZONE 3 PRE/LINE OUT jacks: Output audio signals with
an analog audio cable to a pre-main amplifier or power
amplifier in a separate room (ZONE 3). ( P17)
16. ZONE 2 PRE/LINE OUT jacks: Output audio signals with
an analog audio cable to a pre-main amplifier or power
amplifier in a separate room (ZONE 2). ( P17)
17. SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a
subwoofer cable. Up to two powered subwoofers can be connected. The
same signal is output from each of the SUBWOOFER PRE OUT jacks.
18. PRE OUT jacks: Connect a power amplifier.
19. IR IN A/B, IR OUT jacks: Allows you to connect a
multiroom remote control kit.
20. 12V TRIGGER OUT A/B/C jacks: Allows you to connect
a device with 12V trigger input jack to enable link
operation between the device and the unit.
11
Advertisement
Table of Contents
