Installing The Lower Handlebar Assembly And Shields; Washer; Hex Bolt (M8 X 40 Mm) - Toro 58604 Operator's Manual

2
Installing the Lower
Handlebar Assembly and
Shields
Parts needed for this procedure:
2 Locknut (M8)
2

Washer

2

Hex bolt (M8 x 40 mm)

1 Left side shield
1 Right side shield
1 Pulley box cover
Procedure
1. Align the lower handlebar assembly mount holes
with the lower mount holes on the pulley box and
secure both sides of the assembly as shown.
1. Locknut—M8 (2)
2. Washer (2)
Figure 7
3. Hex bolt—M8 x 40 mm (2)
2. Rotate the lower handlebar assembly away from
the engine.
3. For each side shield, align the shield grooves
with the center tine shield, slide the side shield
onto the center tine shield, and push it until you
hear/feel it click into place. Ensure that the
shield is secure.
g395575
9
Figure 8
Figure 9
g395578
g358168