Toro 58604 Operator's Manual page 10

2. Remove the lock pin from 1 tine set and slide off
the outer tine. Rotate it and slide it on to align
with the second hole of the inner tine. Secure it
with the lock pin.
Repeat this step for the other tine set.
Important:
Install the lock pin from the front
of the tiller so that the wire hinges over the
top of the tine pipe and latches to the pin on
the rear of the tine, as shown in
Figure 4
Figure 5
1. Wire hinge point
3.
Figure 5.
1. Arrow following forward
rotation
2. Locknut (M10)
3. Tine shaft sleeve
g395577
g358135
8
Ensure that the arrows on the left tine set follow
forward rotation and slide the set over the tine
shaft sleeve. Align the mounting holes and
secure the tine set to the machine.
Repeat this step for the right tine set.
Figure 6
g395576
4. Lock washer
5. Bolt (M10 x 45 mm)