Jvc Remote Application - JVC KD-X480BHS Instruction Manual

SiriusXM® Radio
[CODE SET] 1 Turn the volume knob to select a number.
2 Press S / T to move to the entry position.
3 Repeat step 1 and step 2 to enter a new 4-digit pass code.
4 Press the volume knob to confirm.
5 Repeat step 1 to step 4 to reconfirm the pass code.
• Make a note of the new pass code to enter channel lock settings for
next time.
[LOCK SETTING] [MATURE CH]: Selects the SiriusXM-defined lock setting. ;
[USER DEFINED]: Selects the individual channels the user wants to
lock. ; [OFF]: Cancels.
[CHANNEL EDIT]*1 1 Turn the volume knob to select a category, then press the knob.
2 Turn the volume knob to select a channel you want to lock, then
press the knob.
"L" appears in front of the channel number.
3 Press and hold
[CHANNEL CLEAR]*1 [YES]: Clears all the locked channels. ; [NO]: Cancels.
[TUNE START]*2 [ON]: All qualified music channels in the SmartFavorites will start
playback from the beginning of the song. ; [OFF]: Cancels.
[SIGNAL LEVEL] Shows the strength ([NO SIGNAL]/[WEAK]/[GOOD]/[STRONG]) of
the current received signal.
[BUFFER USAGE] Shows the memory usage ([0%] to [100%]) for Replay buffer.
[SXM RESET] [YES]: Resets all SiriusXM settings to default. ; [NO]: Cancels.
*1 Displayed only when [LOCK SETTING] is set to [USER DEFINED].
*2 Available only if the connected SiriusXM Vehicle Tuner is SXV200 or later which supports
SmartFavorites.
to exit.

JVC Remote Application

You can control the JVC car receiver from iPhone/iPod touch (via Bluetooth
or via USB input terminal) or Android device (via Bluetooth) using
JVC Remote application.
• For more information, visit <https://www.jvc.net/cs/car/>.
Preparation:
Install the latest version of JVC Remote application on your device before
connecting.
Start using JVC Remote application
1 Start up the JVC Remote application on your device.
2
Connect your device.
• For Android device:
Pair the Android device with this unit via Bluetooth. (Page 19)
• For iPhone/iPod touch:
Connect iPhone/iPod touch to the USB input terminal. (Page 10)
(or)
Pair the iPhone/iPod touch with this unit via Bluetooth. (Page 19)
(Make sure the USB input terminal is not connected to any device.)
3 Select the device to use from the menu.
See the following "Settings to use JVC Remote application".
By default, [ANDROID] is selected. To use iPhone/iPod touch, select [YES]
for [IOS].
Settings to use JVC Remote application
1 Press and hold .
2 Turn the volume knob to select an item (page 18), then press the
knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press .
17
ENGLISH