Table of Contents
Advertisement
Installation
Lower ventilation slit
The appliance can be ventilated via the
cabinet plinth with the ventilation grille
supplied or with a minimum ventilation
2
opening of 31 in
When using the grille supplied, please
proceed as follows:
Cut an opening in plinth as shown
in the diagram.
Place ventilation grille in the open-
ing.
Push snap fasteners into the venti-
lation grille from behind until the
hooks touch the plinth.
Reinstall the plinth with the ventilation
grille.
20
cross-section area.
Cabinet doors
An upper cabinet door for the refrigera-
tor section and a lower cabinet door for
the freezer section are required.
The cabinet doors must be at least
5/8" (16 mm) / 3/4" (19 mm) thick.
– Weight of the door panel
If the door panel is too heavy
damage can occur.
Installing a door panel which is heav-
ier than the maximum permitted
weight could damage the hinges.
This can cause subsequent func-
tional problems.
Before installing the door panel, en-
sure that the weight of the door
panel does not exceed the maximum
permitted weight.
The maximum permissible weights of
the door panels in lb (kg) are:
Appliance
KFN 7784 D
Upper
Lower
door
door
panel
panel
39.7 (18)
26.5 (12)
Advertisement
Table of Contents
