Thank you for purchasing a surface texture meter from PCE Instruments. The surface texture meter PCE-RT 10 is a small, light device with a very simple navigation. Despite the fact that the device functions on a very complex and elaborated level, the measurement results can be gained very easily and in a comfortable way.
9. Measurement unit 10. Cutoff frequency 11. Start button 12. Cutoff frequency button 13. µm / µinch button / Down Delivery content 1 x Surface texture meter PCE-RT 10 1 x Calibration plate 1 x User’s manual 1 x Screwdriver...
Manual Measuring procedure 4.3.1 Preparations 1. Switch on the device to check the battery level 2. The device will automatically set the conditions of the last measurement. Because of that all settings should be checked properly. 3. In order to check the settings the parameter button needs to be pressed. 4.
Manual 4.3.2 Perform measurements Press the Start button when all preparations are made. The display shows “- - - -“ while the measurement is made. After the selected area has been detected the probe only moves backwards to the position from where measurements are started.
Manual 4.4.3 Travel length L = Length of the sampling n = amount of the sampling length I x n = Length of the calculation 4.4.4 Recommended length of the cutoff frequency Ra (µm) Rz (µm) Cutoff frequency length (mm) >5 …...
In order to comply with the EU directive 2012/19/EU we take our devices back. We either re-use them or give them to a recycling company which disposes of the devices in line with law. If you have any questions, please contact PCE Instruments. Contact If you have any questions about our range of products or measuring instruments please contact PCE Instruments.