Setup By Manual Search; Display The Stb Brand Code; Setup By Learning Function - Tele System Semplice Manual

CAUTION
If the code is wrong, the LED will flash 3 times and turn off; in this last case, repeat the procedure.
5. Check the functions of the buttons of the remote control. If it does not function correctly, try another 4-
digit STB code from the list under the same brand by repeating the steps from 1 to 5 until all basic
functions operate correctly.
If the STB brand is not present in the list or the setup is unsuccessful, try the next method.

4.2.2 Setup by manual search

1. Switch on the STB.
2. Keep pointed the remote control at your STB for all the procedure.
3. Press and hold the STB button for 3 seconds until the LED lights up.
4. Press the P + button progressively. If necessary, press P- to recall the previous code.
5. As soon as the STB responds to the command, by going in stand-by or changing channel, press the OK
button to save the code. The LED will turn OFF.
6. Check whether the other buttons of the remote control function properly. If the majority of the buttons
does not function correctly, repeat the procedure starting from the first step.

4.2.3 Display the STB brand code

To identify the STB brand code in use by the remote control, follow these steps:
1. Press and hold the STB button for 3 seconds until the LED lights up.
2. Press and hold the STB button for 3 second, then release it.
3. To get the first digit of the code, press singularly the numeric button from 0 to 9 until the LED flashes
once. The number that lights up the LED corresponds with the searched digit.
4. Repeat the above step 3 times in order to find the remaining three digits of the code.
5. After having the last digit of the code, the LED will turns OFF.
NOTE
When the STB button is not programmed or after a reset 0 , the code is 0000.

4.2.4 Setup by learning function

The learning function is used to extend the default programs of the standard STB code list (see the
attachment TV/STB List), thanks to the Learning function. A fully functional original remote control of the
STB is required. Please also use new batteries for both the original STB remote control and the Learning
remote control.
1. Press and hold the STB button of the Learning remote control. Release it when the LED turns on.
2. Press and hold the
3. Align the IR sensors of both remote control units and keep them so at a closed distance (around 3 cm)
for all the procedure.
4. Press and release the target button on the Learning remote control which you want to program: the LED
will light up.
5. Press the button of the original remote control that match with the button mentioned on previous step. If
the command is accepted, the LED of the Learning remote control will restarts flashing.
CAUTION
The capturing is not immediate, it may take some seconds.
6. Repeat the steps 4 and 5 for all the other buttons to learn from the original remote control.
7. When you finish learning all needed buttons, press the TV button to save all commands you have learnt
from original remote control and exit the learning mode.
CAUTIONS
•
Every button keeps the learned function even after changing the STB program code. For restoring the
original function of the buttons, perform a reset (see par.0).
•
The buttons TV, STB and
button until the LED starts flashing: now the remote control is in learning mode.
are not programmable.
TELE System
5