Stb Codes Deleting (Reset); Remote Control Programming - Tele System Semplice Manual

SEMPLICE

4.2.5 STB codes deleting (Reset)

To delete all the codes set for the STB button, proceed as follows:
1. Press and hold the STB button of the Learning remote control. Release it when the LED turns on.
2. Press and hold the
3. Press and hold again the
CAUTION
A reset will cancel any learned function and restore the STB code to 0000. In this condition, the RCU doesn't
emit any signal

5 Remote control programming

PROBLEM
The remote control does not work. -The appliance is in Stand-by.
Some buttons do not work
CAUTION
- TV, LED, STB, keys are no programmable during Auto learning mode.
- Because of the large number of TV equipment available in the market, it is not possible to guarantee the
compatibility with all devices.
6
button until the LED starts flashing.
button until the LED turns OFF: the reset is done.
POSSIBLE CAUSE
-The remote control is not being
directed towards the receiver.
-The remote control batteries are
flat.
-The batteries have been inserted
in the wrong direction.
-The remote control has been
dropped
components have been damaged.
-Wrong remote control mode in
use.
-Buttons are not pre-programmed
- Buttons has been programmed
by learning function and later an
TV or STB code has been set
and its internal
REMEDY
-Press the STAND-BY button on
the appliance to check if the
device is working properly.
-Make sure nothing is obstructing
the front panel.
-Change batteries.
-Check the battery polarities.
-Contact the local dealer and buy
a new remote control.
-Press STB or TV button and
check the response of the box.
-Programme the buttons by using
the learning function (ref. 4.1.4
and/or 4.2.4)
- Perform a reset of the TV and/or
STB code (ref. 4.1.5 and/or 0)