Display The Tv Brand Code; Setup By Learning Function; Tv Codes Deleting (Reset); Stb Button Programming - Tele System Semplice Manual

SEMPLICE

4.1.3 Display the TV brand code

To identify the TV brand code in use by the remote control, follow these steps:
1. Press and hold the TV button for 3 seconds until the LED lights up.
2. Press and hold the STB button for 3 second, then release it.
3. To get the first digit of the code, press singularly the numeric button from 0 to 9 until the LED flashes
once. The number that lights up the LED corresponds with the searched digit.
4. Repeat the above step 3 times in order to find the remaining three digits of the code.
5. After having the last digit of the code, the LED will turns OFF.
NOTE
When the TV button is not programmed or after a reset (par. 4.1.5), the code is 0000.

4.1.4 Setup by learning function

The learning function is used to extend the default programs of the standard TV code list (see the attachment
TV/STB List), thanks to the Learning function. A fully functional original remote control of the TV set is
required. Please also use new batteries for both the original TV remote control and the Learning remote
control.
1. Press and hold the TV button of the Learning remote control. Release it when the LED turns on.
2. Press and hold the
3. Align the IR sensors of both remote control units and keep them so at a closed distance (around 3 cm)
for all the procedure.
4. Press and release the target button on the Learning remote control which you want to program: the LED
will light up.
5. Press the button of the original remote control that match with the button mentioned on previous step. If
the command is accepted, the LED of the Learning remote control will restarts flashing.
CAUTION
The capturing is not immediate, it may take some seconds.
6. Repeat the steps 4 and 5 for all the other buttons to learn from the original remote control.
7. When you finish learning all needed buttons, press the TV button to save all commands you have learnt
from original remote control and exit the learning mode.
CAUTIONS
•
Every button keeps the learned function even after changing the TV program code. For restoring the
original function of the buttons, perform a reset (see 4.1.5).
•
The buttons TV, STB, LED and

4.1.5 TV codes deleting (Reset)

To delete all the codes set for the TV button, proceed as follows:
1. Press and hold the TV button of the Learning remote control. Release it when the LED turns on.
2. Press and hold the
3. Press and hold again the
CAUTION
A reset will cancel any learned function and restore the TV code to 0000. In this condition, the RCU doesn't
emit any signal

4.2 STB button programming

4.2.1 Setup by STB brand code

The default STB brand codes are listed in the attachment TV/STB List. Detect the brand of your STB set,
then follow these steps:
1. Switch on the STB.
2. Press and hold the STB button for 3 second. Release it as soon as the LED indicator is lighted up.
3. Enter the 4-digit STB brand code by using the numeric buttons 0÷9.
4. The LED will turn off if the remote control accepts the code.
4
button until the LED starts flashing: now the remote control is in learning mode.
are not programmable.
button until the LED starts flashing.
button until the LED turns OFF: the reset is done.