Basic Info; How To Use The Remote Control; Remote Control Programming; Tv Button Programming - Tele System Semplice Manual

2 Basic info

After completing the programming process of the universal remote All.in.one, you can operate a maximum
of 2 different devices: TV and decoder (or, in lieu of one of the two and using the learning function, a DVD /
HDD / recorder or VCR).
After having properly programmed the remote control unit for controlling the STB or TV set, it will work like
the original remote control of the TV set, limited to main functions, such as On/Standby switching, audio
volume adjustment and channel change.
NOTE
In the following chapter we use the acronym STB that means Set Top Box to indicate the receiver equipment.

3 How to use the remote control

Press the proper function button STB or TV to control respectively the receiver or the TV set, then point the
remote control at the IR sensor of the target device. At each IR transmission, the LED indicator will blink.

4 Remote control programming

4.1

TV button programming

4.1.1 Setup by TV brand code

The default TV brand codes are listed in the TV/STB List. Detect the brand of your TV set, then follow these
steps:
1. Switch on the TV set.
2. Press and hold the TV button for 3 second. Release it as soon as the LED indicator is lighted up.
3. Enter the 4-digit TV brand code by using the numeric buttons 0÷9.
4. The LED will turn off if the remote control accepts the code.
CAUTION
If the code is wrong, the LED will flash 3 times and turn off; in this last case, repeat the procedure.
5. Check the functions of the buttons of the remote control. If it does not function correctly, try another 4-
digit TV set code from the list under the same brand by repeating the steps from 1 to 5 until all basic
functions operate correctly.
If the TV brand is not present in the list or the setup is unsuccessful, try the next method.

4.1.2 Setup by manual search

1. Switch on the TV set.
2. Keep pointed the remote control at your TV set for all the procedure.
3. Press and hold the TV button for 3 seconds until the LED lights up.
4. Press the P + button progressively.
5. If necessary, press P- to recall the previous code.
6. As soon as the TV set responds to the command, by going in stand-by or changing channel, press the OK
button to save the code. The LED will turn OFF.
7. Check whether the other buttons of the remote control function properly. If the majority of the buttons
does not function correctly, repeat the procedure starting from the first step.
1. LED: Led marker used during the setup
2. TV press shortly to enter to TV control mode
press more than 3 sec to enter to setup mode
3. STB: press shortly to enter to STB control mode
press more than 3 sec to enter to setup mode
: reserved to the setup mode
4.
TELE System
3