Fm/Am Radio; Usb And Network - Yamaha HTR-7065 Owner's Manual

FM/AM radio

Problem
FM radio reception is weak or noisy.
AM radio reception is weak or noisy.
Radio stations cannot be selected automatically.
AM radio stations cannot be registered as
presets.

USB and network

Problem
The unit does not detect the USB device.
Folders and files in the USB device cannot be
viewed.
The network feature does not function.
The unit does not detect the PC.
Cause
There is multi-path interference.
Your area is too far from the FM station transmitter.
The noises may be caused by fluorescent lamps, motors,
thermostats, or other electrical equipment.
Your area is too far from the FM station transmitter.
The AM radio signal is weak.
Auto Preset has been used.
Cause
The USB device is not connected to the USB jack securely.
The file system of the USB device is not FAT16 or FAT32.
The data in the USB device is protected by the encryption.
The network parameters (IP address) have not been obtained
properly.
The media sharing setting is not correct.
Some security software installed on your PC is blocking the access
of the unit to your PC.
The unit and PC are not in the same network.
Remedy
Adjust the FM antenna height or orientation, or place it in a different location.
Set "FM Mode" in the "Option" menu to "Mono" to select monaural FM radio
reception (p.80).
Use an outdoor FM antenna. We recommend using a sensitive multi-element
antenna.
It is difficult to completely eliminate noise. It may be reduced by using an outdoor
AM antenna.
Select the station manually (p.53).
Use an outdoor antenna. We recommend using a sensitive multi-element
antenna.
Adjust the AM antenna orientation.
Select the station manually (p.53).
Use an outdoor AM antenna. Connect it to the ANTENNA (AM) jack together with
the supplied AM antenna.
Auto Preset is for registering FM radio stations only. Register AM radio stations
manually (p.54).
Remedy
Turn off the unit, reconnect your USB device, and turn the unit on again.
Use a USB device with FAT16 or FAT32 format.
Use a USB device without an encryption function.
Enable the DHCP server function on your router and set "DHCP" in the "Setup"
menu to "On" on the unit (p.98). If you want to configure the network parameters
manually, check that you are using an IP address which is not used by other
network devices in your network (p.98).
Configure the sharing setting and select the unit as a device to which music
contents are shared (p.65).
Check the settings of security software installed on your PC.
Check the network connections and your router settings, and then connect the
unit and the PC to the same network.
APPENDIX ➤ Troubleshooting
116
En