Connecting Front Speakers That Support Bi-Amp Connections - Yamaha HTR-7065 Owner's Manual

1 2 3 4 5 6 7 8 9 10
Speaker connections
Push-type speaker terminals
(HTR-6065 only)
a Remove approximately 10 mm (3/8") of insulation from
the ends of the speaker cable, and twist the bare wires of
the cable firmly together.
b Press down the tab.
c Insert the bare wires of the cable into the hole in the
terminal.
d Release the tab.
E 2
/P R
E X E S
T R
E N
A S C E
P
a a
d b
+ (red)
c
- (black)
■
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
Audio pin cable
Connecting front speakers that
support bi-amp connections
When using front speakers that support bi-amp
connections, connect them to the FRONT jacks and
SURROUND BACK/BI-AMP jacks.
To enable the bi-amp function, set "Power Amp Assign"
(p.91) in the "Setup" menu to "5ch BI-AMP" after
connecting the power cable to an AC wall outlet.
The unit (rear)
SPEAKERS
FRONT CENTER SURROUND SURROUND BACK/BI AMP
SINGLE
SINGLE CENTER
AUDIO ZONE 2 FRONT SURROUND SUR. BACK 1 SUBWOOFER 2
OUT OUT PRE OUT
1 2
3
9
4
Caution
• Before making bi-amp connections, remove any brackets or
cables that connect a woofer with a tweeter. Refer to the
instruction manual of the speakers for details. If you are not
making bi-amp connections, make sure that the brackets or
cables are connected before connecting the speaker cables.
• Surround back speakers cannot be used during bi-amp
connections.
ZONE 2/PRESENCE
EXTRA SP
5
PREPARATIONS ➤ Connecting speakers
21
En