Configuring The System Settings (Advanced Setup Menu); Advanced Setup Menu Items; Changing The Speaker Impedance Setting (Sp Imp.) - Yamaha HTR-7065 Owner's Manual

Configuring the system settings
(ADVANCED SETUP menu)
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE z.
MAIN ZONE z
PROGRAM STRAIGHT
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE z to set the unit to standby mode and turn it on
again.
The new settings take effect.

ADVANCED SETUP menu items

Item Function
SP IMP. Changes the speaker impedance setting.
REMOTE ID Selects the unit's remote control ID.
TV FORMAT Switches the video signal type.
MON.CHK Removes the limitation on HDMI video output.
INIT Restores the default settings.
UPDATE Updates the firmware.
VERSION Checks the version of firmware currently installed on the unit.

Changing the speaker impedance setting (SP IMP.)

SP IMP. 8 MIN
Change the unit's speaker impedance settings depending on the impedance of the
speakers connected.
Settings
Select this option when you connect 6-ohm speakers to the unit. You
6 Ω MIN
can also use 4-ohm speakers as the front speakers.
Select this option when you connect 8-ohm or higher speakers to the
8 Ω MIN (default)
unit.
CONFIGURATIONS ➤ Configuring the system settings (ADVANCED SETUP menu)
Page
105
106
106
106
106
107
107
105
En