Listening To Fm/Am Radio; Setting The Frequency Steps; Selecting A Frequency For Reception - Yamaha RX-V483 Owner's Manual

Listening to FM/AM radio

You can tune into a radio station by specifying its frequency or selecting from
registered radio stations.
Note
▪ The radio frequencies differ depending on the country or region where the unit is being used. The
explanation of this section uses a display with frequencies used in U.K. and Europe models.
▪ If you cannot obtain good reception on the radio, adjust the direction of the FM/AM antennas.

Setting the frequency steps

(Asia, Taiwan, Brazil and General models only)
At the factory, the frequency step setting is set to 50 kHz for FM and 9 kHz for AM.
Depending on your country or region, set the frequency steps to 100 kHz for FM and
10 kHz for AM.
1
Set the unit to standby mode.
2
When holding down STRAIGHT on the front panel, press z
(power).
z (power)
PROGRAM STRAIGHT
3
Press PROGRAM repeatedly to select "TU".
LINK MASTER
OUT 2 -R es
Hi ENHANCER
ECO
TU••••FM50/AM9
STEREO TUNED ZONE
2 A 3 B
SLEEP PARTY
YPAO VOL. A- DRC
VOL. MUTE VIRTUAL
FPL FPR
SL SW SR
SBL SB SBR
4
Press STRAIGHT to select "FM100/AM10".
5
Press z (power) to set the unit to standby mode and turn it on
again.

Selecting a frequency for reception

1
Press FM/AM to select a band.
"TUNER" is selected as the input source and then the frequency currently
selected is displayed.
LINK MASTER
OUT 2
ECO
FM 87.50MHz
51
En
STEREO TUNED ZONE
SLEEP PARTY 2 A 3 B
Hi -R es ENHANCER YPAO VOL. A- DRC
VOL. MUTE VIRTUAL