Table of Contents
Advertisement
8.4 Oil filter replacement procedure
Use exclusively oil filter P/N: 1520865F0B.
- Clean carefully the oil filter area prior to remove the old one.
- Remove old oil filter.
- Apply a small amount of oil on the seal of the new oil filter.
- Assemble the oil filter and torque it at 20Nm. Verify minimum 3 times the torque (filter shouldn't
move) and mark its final position with a paint pencil.
8.5 Clutch tightening procedure:
- Read and carefully follow the Sachs instructions enclosed in the clutch box.
- Apply Loctite 243 and torque clutch nuts at 22Nm.
DON'T FORGET TO REMOVE THE INSTALLATION CLIP!
8.6 Fly wheel tightening procedure:
- It is recommended not to use the flywheel screws several times.
- Before tightening, apply copper grease or ARP grease on the thread and on the underside of the
screw head and torque fly wheel screw at 90 Nm.
MR18 F3R Engine user manual V03, February 2021
Page 25 sur 29
Advertisement
Table of Contents
