Table of Contents
Advertisement
3. RINSE
Rinse the filter with warm water, clean side to dirty side to flush out the dirt.
4. DRYING
Allow the filter to dry naturally. Try to avoid heat because it might shrink the cotton. If you use an air
gun, do not blow closer than 30cm from the air filter and do it carefully, otherwise the air flow will
generate holes
5. APPLY OIL
Re-oil the filter using Green Filter Oil by using 1 spray per 2 square inches of filter. Take care to not
over-oil your filter. Remove the excess of oil on the rubber. Air filter is ready to use. OIL FOR FOAM
AIR FILTER IS STRONGLY PROHIBITED
* Never use motor oil, transmission fluid, WD-40®, or any other brand of filter oil as these
may damage your Green Filter. Use only genuine Green Filter Oil.
8.3 Spark plug replacement procedure
Spark plug replacement is requested at 5,000kms from last rebuild achieved. Use exclusively spark
plugs set 7711168144.
- Remove carefully the coils and blow air prior to remove the old spark plugs.
- Remove old spark plugs.
- Apply a small amount of copper grease on the threads of new spark plugs.
- Assemble the new spark plugs. Torque it by hand to compress the seal. Release it and torque it again
at 17Nm.
MR18 F3R Engine user manual V03, February 2021
Special care must be taken when fitting back the coils.
Ensure that the coil connector number fits on the correct
cylinder number.
Page 24 sur 29
Advertisement
Table of Contents
