Table of Contents
Advertisement
5. Engine usage
5.1 Oil system
Oil filter is changed also after the bench breaking-in and power curves. Make sure to clean carefully
all oil pipes and oil tank (in bellhousing) before you mount a new or rebuilt engine in the car.
5.2 General:
Prevent the engine loom and the ECU loom from unlikely conditions that could cause damages:
- do not crush the loom.
- avoid friction on sharp or exposed edges.
- use preventive devices such as rub wraps where it is necessary.
- design a proper thermal insulation in order to protect the alternator and its loom.
- make sure that all electronic devices are properly fixed and cannot be damaged by vibrations.
5.3 Maintenance after each event:
- check the loom and all connectors.
- check all power connections on alternator, electric starter, chassis ground and power.
MR18 F3R Engine user manual V03, February 2021
Only Castrol Edge Titanium 10W60 can be used in the MR18 F3R
engine.
Extreme care must be taken with the routing of all wiring looms
and positioning of equipment to avoid damage to wiring insulation
or over-stressing of internal cables.
Page 14 sur 29
Advertisement
Table of Contents
