Kärcher BR 47/35 ESC Original Instructions Manual page 24

Replacing the roller brushes and the in-
take brushes
 Loosen all the four screws and remove
the bearing lid.
 Remove the roller brushes (large) and
intake brushes (small) and replace
them (pay attention to the hexagonal in-
take of the brushes!).
Also check simultaneously the combs
and the guide rails and replace or clean
them as required.
Replacing the combs
 Remove the combs and replace them.
To do this, slide the inlet combs on the
narrow rails and the outlet combs on the
wider rails.
24
m-master.com.ua
EN
m-master.com.ua
+38(050) 187 08 87 | +38(096) 187 08 87
Cleaning the suction nozzles
 Pull out all dirt particles from the suction
nozzles; do not push them in.
Replacing the guide rails
 Loosen the fastening screws of the
holder for the guide rails.
 Dismantle the guide rails.
 Insert the guide rails in reverse se-
quence. Ensure that they sit properly.
Check nozzles and filters for detergents
 Loosen the union joint. Remove nozzle,
washer and sieve.
 Clean the nozzle or insert a new nozzle
in the union joint.
 Insert washer and sieve and tighten the
union joint by hand.
– 8
+38(050) 187 08 87 | +38(096) 187 08 87