Flex CSE 55 T Operating Instructions Manual page 26

Switching on and off
`^rqflk>
cçê=êÉ~ëçåë=çÑ=ë~ÑÉíó=íÜÉ=ëïáíÅÜ=áë=åçí=äçÅâÉÇ=
~åÇ=ãìëí=ÄÉ=ÜÉäÇ=Ççïå=ÇìêáåÖ=ë~ïáåÖK
qÜÉ=ëïáíÅÜ=áåíÉêäçÅâ=éêÉîÉåíë=íÜÉ=éçïÉê=íççä=
Ñêçã=ÄÉáåÖ=ëïáíÅÜÉÇ=çå=ìåáåíÉåíáçå~ääó=~åÇ=
äçÅâë=íÜÉ=Öì~êÇK
fåáíá~ääó=~äï~óë=ëïáíÅÜ=çå=ë~ï=áå=ïçêâáåÖ=
éçëáíáçåK
 Press up and hold down the switch
interlock (1.).
 Press and hold down the switch (2.).
 Release switch interlock (when the saw
has been plunged).
Switching off:
 Release the switch.
Parallel stop (optional).
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
klqb
_ÉÑçêÉ=íÜÉ=ë~ï=Å~å=ÄÉ=éä~ÅÉÇ=áå=íÜÉ=ëìééäáÉÇ=
íê~åëéçêí~íáçå=Å~ëÉI=íÜÉ=é~ê~ääÉä=ëíçé=ãìëí=
ÄÉ êÉãçîÉÇK
The parallel stop can be attached on the left
or right in the direction of thrust of the saw.
The stop edge can be attached above
or below.
26
Stop edge upwards  Increases the contact
surface of the saw bench.
Stop edge downwards  Facilitates cutting
parallel to the workpiece edge.
Attaching parallel stop:
 Attach wing screw/clamping bracket/
spring for mounting the parallel stop (1.).
 Insert parallel stop (stop edge up or down)
and set to required width (2.).
 Tighten the wing screw (3.).
CSE 55 T