Stiga Cruiser CR 430 Li 80 Series Operator's Manual page 119

PROBLEM
4. The motor is running
but the cutting means
is stationary
5. The cut grass is
not collected in the
grass catcher
6. Mowing is difficult
7. Excessive noise and/or
vibration is experienced
whilst working
8. Battery power
reserve is low
9. The battery charger
is not recharging
the battery
If problems persist after having performed the above operations, contact your dealer.
15. ATTACHMENTS ON REQUEST
15.1 "MULCHING" KIT
It cuts the grass cuttings finely and leaves them on
the lawn, instead of collecting them in the grass
catcher (for compatible machines) (Fig. 24).
PROBABLE CAUSE
The cutting means fittings are loose
The cutting means has collided with a
foreign object and received a knock
The inside of the chassis is dirty
The cutting means is not
in good condition
Cutting means fittings are loose or
the cutting means is damaged
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Battery is not correctly inserted
in the battery charger
Unsuitable environmental conditions
Dirty contacts
The battery charger is not energised
Faulty battery charger
Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical Assistance
Centre for correct fastening support (par. 8.1)
Turn off the motor
Inspect for damage and
Contact a Technical Assistance Centre
for the replacement of the cutting
means if necessary. (par. 8.1)
Clean the inside of the chassis to
ease the grass discharge towards
the grass catcher (par. 7.3.1)
Contact a Technical Assistance
Centre for the sharpening or
replacement of the cutting means
Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical
Assistance Centre for checks,
replacements or repairs (par. 8.1)
Optimise operations
(par. 7.2.1)
Use a second battery or an
extended battery (par. 15.2)
Check it is correctly inserted (par. 7.2.2)
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an original spare part
If the problem persists, refer to the battery/
battery charger manual
15.2 ALTERNATIVE BATTERIES
Different capacity batteries are available to
suit specific operating requirements (Fig. 25).
The list of approved batteries for this machine
is found in the "Technical Data" table.
EN - 12
REMEDY
and remove the safety key.