Stiga Cruiser CR 430 Li 80 Series Operator's Manual page 117

If the machine is stored in places that could exceed
these thresholds, it is recommended to remove the
battery and store it in a more suitable location.
10. HANDLING AND TRANSPORTATION
Whenever the machine is to be handled,
raised, transported or tilted you must:
– stop the motor;
– remove the safety key;
– make sure that all moving parts have
come to a complete stop;
– wear heavy work gloves;
– hold the machine in the points offering a safe grip,
taking into account the weight and its division;
– use an appropriate number of people for the weight
of the machine and the characteristics of the vehicle
or the place where it must be placed or collected;
– make sure that machine movements do
not cause damage or injuries.
2) During transport:
– fasten the machine securely with cables or chains.
– position it so that it can not cause
a hazard for anybody.
11. ASSISTANCE AND REPAIRS
This manual provides all the necessary information
to run the machine and for correct basic maintenance
operations which can be performed by the user. Any
regulations and maintenance operations not described
herein must be carried out by your Dealer or Authorised
Service Centre, which have the necessary knowledge
and equipment to ensure that the work is carried out
correctly, maintaining the correct degree of safety and
the original operating conditions of the machine.
13. MAINTENANCE TABLE
The boxes at the side are for you to mark the date or number of working hours at which the maintenance was made.
Operation
MACHINE
Safety checks/check controls
Check the rear discharge / side
discharge guards. Check the grass-
catcher, side discharge chute
Check the battery charge status
Recharge the battery
* Refer to the battery/battery charger manual.
** Operation to be performed at the first signs of any malfunction
*** The operation must be carried out by your Dealer or a specialised Service Centre
Any operations performed in unauthorised centres or by
unqualified persons will totally invalidate the Warranty and
all obligations and responsibilities of the Manufacturer.
• Only authorised service workshops can carry
out guaranteed repairs and maintenance.
• The authorised service workshops only use genuine
spare parts. Genuine spare parts and attachments
have been designed specifically for machines.
• Non-original parts and attachments are not approved;
use of non-original spare parts and attachments
will jeopardise the safety of the machine and relieve
the Manufacturer from all obligations or liabilities.
• It is advisable to send your machine once a year
to an authorised service workshop for servicing,
assistance and safety device inspection.
12. WARRANTY COVERAGE
The warranty covers all material and manufacturing
defects. The user must follow all the instructions
provided in the accompanying documentation.
The warranty does not cover damages caused by:
• Failure to become familiar with the
documentation accompanying the machine
• Carelessness
• Incorrect or prohibited use or assembly
• Use of non-genuine spare parts
• Use of attachments not supplied or
approved by the manufacturer
The warranty does not cover:
• Normal wear and tear of consumables, such
as wheels, blades, safety bolts and wires
• Normal wear and tear
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
Frequency Completed (Date or Hours)
(hours)
Before
each use
Before
each use
Before
each use
After each
use
EN - 10
Notes
par. 6.2
par. 6.1.2
*
par. 7.2.2
*