Canon Color imageCLASS MF8350Cdn Starter Manual page 12

Use numeric keys, and then press [OK].
Current Time Settings
2010 01/01 12:52
•
Move the cursor with [ ] or [ ].
•
Switch to <AM> or <PM> with [ ] or [ ].
Performing Color Correction
Color correction takes approximately 165
seconds.
Make sure that paper is loaded,
and then press [OK].
Supported paper:
Size: A4, LTR, 16K
Type: Plain 1/2, Rec
OK
Confirm the procedures for the color
correction, and then press [OK].
Steps (Start:Press OK)
1. Print Adj. Image 1
2. Scan Adj. Image 1
The test chart (adjusted image 1) is printed.
Place the test chart with the printing side face down.
Place the paper setting the direction of black streak to the
back side of the platen glass.
Press [ ] (Start).
Remove the test chart (adjusted image 1) placed on the platen glass in Step
4
AM
Check the temperature of the installation site.
If the room temperature is low, correction may not be performed properly.
If <Adjustment failed.> appears
• Is the paper loaded correctly?
→
Load plain paper or recycled paper of A4/Letter size in the paper cassette.
• Is the test chart placed on the platen glass correctly?
→
Place the test chart with the printing side face down and the black streak toward
the back of the machine.
• Has a paper jam occurred?
→
Remove the jammed paper.
Step 1
Printing adj. image 1.
Place adj. image 1 on
the glass with black
side toward the back.
Press [Color] start.
Press [OK].
Adjust image to
reproduce original
color?
Yes No
•
You can perform color correction by
selecting <Yes> to obtain optimum
copy results or printout results.
For details on the procedure, see
the following "Performing Color
Correction."
Open the feeder.
Close the feeder.
Step 2
Scanning adj. image 1.
Initial screen appears, and
initial setting is finished.
Copy: Press Start
100% A4
1
+ -
Density: 0
Original Type: Text...
2-Sided: Off
Copy Image Adjustment
.
1