Layout And Items Supplied; Proper Use; Technical Data - EINHELL CC-PO 1100/2 E Original Operating Instructions

the sandpaper becoming jammed or torn, or
produce kick-back.
Special safety instructions for polishing:
a) Make sure there are no loose parts, in parti-
cular fastening ties, on the polishing bonnet.
Roll up or shorten the fastening ties. Loose,
rotating ties may catch your fi ngers or get
jammed in the workpiece.
Do not lose these safety instructions

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Spindle lock
2. Front grip
3. ON/OFF switch
4. Speed control
5. Rear grip
6. Power cord
7. Polishing / sanding disk
8. Speed indicator
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
1 Sanding and polishing machine
2 Additional handle
Anl_SA_CC_PO_1100_E_SPK8.indb 29 Anl_SA_CC_PO_1100_E_SPK8.indb 29
GB
3 Polishing / sanding disk
4 Foamed plastic attachment
5 Synthetic polishing attachment
6 Sanding attachment K = 60
7 Sanding attachment K = 80
8 Sanding attachment K = 120
9 Allen key 8 mm
10 Screw M10x20 mm (2x)
•
Original operating instructions

3. Proper use

The machine is designed for polishing coated
surfaces and for sanding wood, iron, plastic and
similar materials using the appropriate abrasive
paper.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

See warranty card of your country.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Warning!
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
- 29 -
27.09.2017 08:57:41 27.09.2017 08:57:41