Table of Contents
Advertisement
MODEL 44-50
VIBRATORY
DRIVER/EXTRACTOR
III.
OPERATING INSTRUCTIONS
A. COMPLETION OF SET-UP AND MAINTENANCE
1. Complete all preparation as described in Section II.
2. Read Section IV - MAINTENANCE AND ADJUSTMENTS and perform any required
maintenance.
B. CONTROL PANEL
1. The control box (Fig. 1, page III-1) at the side of the power pack contains the controls
and gages for the diesel engine, vibrator, and the OPERATION AND MAINTENANCE
INSTRUCTIONS.
2. Control panel contains the following controls and gages:
a. Shutdown indicator lights (6) See notes below.
b. Main power switch (Circuit Breaker) - on/off switch for 24 volt electrical power.
c. Engine throttle.
d. Engine shut-down reset button - on start must be held in until oil pressure exceeds 30
PSI.
e. Engine "ON/OFF/START" switch - for diesel engine.
f.
Engine tachometer.
g. Engine oil pressure gage.
h. Engine water temperature gage.
i.
Engine ammeter.
j.
Engine hourmeter.
k. Pressure gage - (Drive - Forward).
l.
Pressure gage - (Brake - Reverse).
m. Pressure gage - (Close).
n. Pressure gage - (Open).
o. Local-Pendant switch.
p. Hydraulic Fluid temperature gage.
r.
Emergency Stop - Push to stop engine
s. Diagnostic light.
x. Clamp light.
y. Clamp switch.
z. Vibrator switch.
Notes: 1. Engine Oil Pressure shutdown indicator - comes on if the engine has been shut down
automatically due to engine oil pressure being low.
2. Engine Water Temperature shutdown - comes on if the engine has been shut down
automatically due to engine water overheating.
3. Engine Overspeed shutdown indicator - comes on if engine has been shut down
automatically due to the engine being run at excessively high RPM's.
III-2
OPERATING
INSTRUCTIONS
Advertisement
Table of Contents
