Table of Contents
Advertisement
28 Getting Started
To turn off the power
Press and hold the POWER button for a few seconds.
A message will then be displayed, prompting you whether or not to turn off
the device completely.
Auto configure the data connection settings
The first time you power on your device, you will see a notification message
from the Connection Setup on the Today screen.
The Connection Setup can automatically configure your device's data
connections, such as GPRS, WAP, and MMS, for you so that you do not need
to enter the settings manually onto your device.
To automatically configure data connection settings
1.
When you see the notification message from the Connection Setup,
tap Yes.
Note
2.
If your SIM card supports multiple network operator profiles, a
message will appear with network profile choices. Select the profile
you want to use and tap OK.
3.
Connection Setup then starts to configure your device's data
connection settings.
4.
After the Connection Setup completes the configuration, tap Restart.
For more information about the Connection Setup, see Chapter 10.
Charge the battery
New batteries are shipped partially charged. Before you start using your
device, it is recommended that you install and charge the battery. Some
batteries perform best after several full charge/discharge cycles. You can
charge the battery in two ways:
•
Charging the device's battery by connecting the power adapter.
•
Connecting your device to a PC via the provided USB Sync cable.
Note
If you do not see the notification message, tap
display the message.
Only the AC adapter and USB cable provided with your device should be
used to charge the device.
on the title bar to
Advertisement
Table of Contents
