Philips Sonicare DiamondClean 300 Series Manual page 10

10
English
9 Charging base
10 Charging travel case (select models)
11 USB wall adapter (select models)
12 USB cord (select models)
Note: The content of the box may vary based on the model
purchased.
Preparing for use
Attaching the brush head
1 Align the brush head so the bristles point in the same direction as
the front of the handle. (Fig. 2)
2 Firmly press the brush head down onto the metal shaft until it
stops.
Charging your Philips Sonicare
1 Plug the charger into an electrical outlet.
2 Place charging glass (select models) on top of the charging base
and place handle in glass (Fig. 3).
- The charge indicator flashes green until fully charged (Fig. 4).
- Rapid yellow flashing indicates charge is extremely low (fewer
than 3 uses left).
Note: It takes at least 24 hours to fully charge the battery.
This charger is designed to properly charge only one handle at a time.
This charger is not compatible with other models of Sonicare.
Do not place metallic objects in the charging glass, as this may affect
the charging process and may cause the charging base to overheat.
Using the appliance
Brushing instructions
1 Wet the bristles (Fig. 5) and apply a small amount of toothpaste
(Fig. 6).
2 Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline (Fig. 7).