HP USB TV Tuner User Manual page 15

To connect the TV tuner to your existing satellite TV or cable TV source with a receiver, follow these
steps:
1.
2.
3.
4.
NOTE:
connections on page
Antenna House XSL Formatter (Evaluation) http://www.antennahouse.com/
Connect an RF coaxial cable (purchased separately) from your cable or satellite TV wall jack (1)
to the TV-In jack on your cable or satellite receiver (2).
Connect an RF coaxial cable (purchased separately) from the TV-Out jack (3) on your cable or
satellite receiver to the TV tuner (4).
NOTE: For improved video quality you can connect your receiver to the TV tuner using a
composite video or S-Video cable instead of an RF coaxial cable. Refer to Chapter 4,
connections on page 17, for instructions.
Insert the TV tuner into a USB port (5) on the computer.
NOTE: Due to power and bandwidth requirements, do not insert the TV tuner into a USB hub.
Connect the remote sensor to a USB port on the computer. Refer to
sensor and infrared (IR) emitter cable on page
For additional connection steps, such as adding a television, refer to Chapter 4,
17.
Step 5: Connect the remote
12, for details.
Step 4: Set up your audio/video connection
Advanced
Advanced
11