Using The Stylus; Aligning The Screen - HP iPAQ rz1700 series User Manual

Using the Stylus

You can use the stylus three ways:
Tap—Lightly touch the screen to select or open an item. Lift the
stylus after you tap an item. Tapping is equivalent to clicking an
item with the mouse on your computer.
Drag—Place the point of the stylus on the screen and drag an
item across the screen without lifting the stylus until you have
completed the selection. Dragging is equivalent to dragging with
the left mouse button pressed on your computer.
Tap and hold—Hold the stylus pointer on an item for a short
time until a menu displays. Tapping and holding is equivalent to
right-clicking your computer mouse button. When you tap and
hold, a circle of red dots appears around the stylus to indicate that
the menu will soon pop up.
Ä
CAUTION: To prevent damage to the screen, never tap or write on the
screen with any device other than the stylus that comes with the device,
or an approved replacement. If you lose or break your stylus, you can
order extras at www.hp.com/go/ipaqaccessories.

Aligning the Screen

The first time you turn on the HP iPAQ, you must align the
screen. You need to realign the screen if:
■
The device does not respond accurately to your taps.
■
You perform a full reset of your device.
To realign the screen:
1. From the Start menu, tap Settings > System tab > Screen.
2. Tap Align Screen and tap the crosshairs as they move on the
screen.
User's Guide
Getting to Know Your HP iPAQ
1–5