Table of Contents
Advertisement
Illustration 1:
Pass the detergent siphon hose (A) under
the machine, aligning the detergent fill hole
on the detergent tank (B) towards the front of
the machine. Place detergent hose (A) into
the detergent hose hole on the back of the
detergent tank (B), and insert until the hose
end rests on the bottom of the deepest part
of the tank.
Illustration 2:
Insert hexagonal ¼" bolts (C) into tank knobs
(D). Insert through the flanges on the edges
of the detergent tank (B), into the holes on
the frame, and tighten.
Illustration 3:
Feed axle (G) through spacer ½" (F) and hub
of wheel (E). Insert assembly into axle mount
at back of frame. Push straight side of cotter
pin (H) through hole in axle until locked in
place. Repeat on other side of unit.
STEP 1:
Pull the spring-loaded collar of the wand back
to insert your choice of quick connect nozzle.
Release the collar and push the nozzle until-
the collar clicks.
CAUTION
High pressure in nozzle area.
Risk of injury caused by improperly locked
nozzle.
ASSEMBLY INSTRUCTIONS
Assembling
OPERATING INSTRUCTIONS
Illustration 4:
Mount nozzle holder (K) to handle as shown
in illustration, align holes, insert ¼" carriage
bolts (L) and secure with knob with nut (M).
Illustration 5:
Attach the handle to the frame of the pres-
sure washer. Align holes in handle with holes
in lower frame, insert carriage bolts (I), and
tighten with knobs (J).
Illustration 6:
Place the quick connect nozzles (N) in the
nozzle holder (K).
Illustration 7:
Push the wand (O) into the spray gun (P) and
then thread the connection to secure.
Illustration 8:
Remove the oil dipstick from the engine and
add correct amount of oil. Be sure oil level is
between "FULL/MAX" and "ADD/MIN" marks
on dipstick with machine on level surface.
Replace cap/dipstick.
Make sure you hear a "click" when inserting
n
the nozzle tip in to the wand.
Pull the nozzle to make sure it is seated
n
properly before operating your unit.
STEP 2:
Attach the high pressure hose to the trigger
gun.
CAUTION
Engine shipped without oil. Before starting
engine, fill with oil. Do not over-fill. Do not
run the engine with a high or low oil level as
this can cause engine damage.
If you have further questions regarding the
engine, please refer to the engine manual
included with the unit.
9
Advertisement
Table of Contents
