Polaris RZR S 1000 2020 Owner's Manual page 61

PROGRAMMABLE SERVICE INTERVAL
When the hours of engine operation equal the programmed service interval
setting, the wrench icon will flash for 5 seconds each time the engine is started.
When this feature is enabled, it provides a convenient reminder to perform
routine maintenance. The service interval is programmed at 25 hours at the
factory. Use the following procedure to change the service interval.
1. Press the MODE button until remaining service hours display.
2. Press and hold the MODE button.
3. When the service hours flash, press and release the MODE button to
advance the hours to the desired setting (including OFF). Press and hold the
MODE button to set the new service hour interval.
DIAGNOSTIC DISPLAY MODE
The EFI diagnostic display mode is for informational purposes only. Your
POLARIS dealer can provide for all major repairs.
The diagnostic mode is accessible only when the check engine warning
indicator activates after the key has been turned on. Leave the key on if you
want to view the active code (failure code).
The diagnostic mode becomes inaccessible if the key is turned off and on and
the warning indicator is no longer active. This allows the determination of
persistent as well as intermittent faults.
Inactive codes are stored in the history of the unit.
ENGINE ERROR CODES
The error screen displays only when the CHECK ENGINE light is on or when it
goes on and off during one ignition cycle. Error codes are not stored in the
gauge when the key is turned off. The code and message is lost, but will
reappear if the fault reoccurs after restarting the engine.
If the CHECK ENGINE light illuminates, retrieve the error codes from the display.
q
Failure Mode Indicator (FMI)
w
Suspect Parameter # (SPN)
e
Count Display
Downloaded from ManualsNet.com
FEATURES AND CONTROLS
search engine
59