Connect Battery Pack; Fig. 11 C9900-U332_Position Terminal Strip - Beckhoff C9900-U332 Manual

Commissioning
4.4

Connect battery pack

Risk of electric shock
Dangerous touch voltages can lead to electric shock. To avoid electric shock, observe the following:
• Never plug or unplug the battery pack cable during a thunderstorm.
• Provide protective earthing for handling the battery pack.
Incorrect connection procedure
Incorrect procedure when connecting the cable can cause hardware damage.
• Follow the documented procedure for connecting the cable.
• Always connect the cable first and only then switch on the power supply of the connected PC.
After you have mounted the battery pack in the control cabinet, you can connect it to the PC.
Grounding
Potential differences are minimized and electrical currents are diverted to the ground through protective
earthing or potential equalization of electronic devices. This is to prevent dangerous touch voltages and
electromagnetic interference.
Connecting the battery pack
You must connect the battery pack to the PC. For this purpose, there is an 8-pin terminal strip (X101) on the
battery pack housing (see Fig. 11).
8
1
Fig. 11: C9900-U332_position terminal strip
Table 3: Pin assignment terminal strip
Pin Function
1 -
2 +
3 Terminal for looping through wires of the supply line to the PC
4
5 Terminal for looping through wires of the supply line to the PC
6 Terminal for looping through wires of the supply line to the PC
7 Terminal for looping through wires of the supply line to the PC
8 Terminal for looping through wires of the supply line to the PC
You can connect two wires on each side of a terminal of the terminal strip. For this purpose, you must use
double wire end sleeves (see Fig. 12).
16
CAUTION
NOTE
BAT
Version: 2.0 C9900-U332