Fig. 10 C9900-U332_Mounting Plate - Beckhoff C9900-U332 Manual

Mounting via mounting plate
In addition to mounting on the DIN rail, you have the option of mounting the battery pack without a DIN rail
using the mounting plate on the rear. You can align the battery pack as you wish.
Two requirements must be met for mounting the battery pack via the mounting plate:
• You must remove the mounting notches from the mounting plate (see earlier in the chapter).
• You must provide the wall on which the battery pack is to be mounted with appropriate drill holes.
Fig. 10: C9900-U332_mounting plate
To mount the battery pack via the mounting plate, follow the steps below:
1. Place the battery pack with the marked locations of the mounting plate (see Fig. 10) in front of the pre-
pared drill holes.
2. Insert the M4 fastening screws into the drill holes.
3. Tighten the fastening screws.
C9900-U332 Version: 2.0
Commissioning
15