Summary of Contents for Hall Technologies DSCV-70-RX
- Page 1 Hall Technologies • 1234 Lakeshore Dr Suite #150 Coppell, TX 75019 • halltechav.com DSCV-70-RX HDBaseT 2.0 Receiver with USB and Audio De-embedding User Manual Version: V1.0.0 Hall Technologies June 8, 2022 Page 1 of 14...
- Page 2 8. Protect the power cord from being walked on or pinched particularly at plugs. 9. Only use attachments / accessories specified by the manufacturer. 10. Refer all servicing to qualified service personnel. Hall Technologies June 8, 2022 Page 2 of 14...
-
Page 3: Table Of Contents
Installation and Wiring ......................9 Installation .......................... 9 Wiring ..........................10 RS232 Operation ........................12 Control the RS232-enabled Device ................. 12 Control the Wall Plate Transmitter ..........Error! Bookmark not defined. Hall Technologies June 8, 2022 Page 3 of 14... -
Page 4: Introduction
Ÿ Supports bi-directional RS232 serial communication to control a wall plate transmitter when paired with the wall-plate transmitter. Ÿ Supports firmware upgrade through the RS232 port. Ÿ Built-in PSE to power remote HDBT Wall plate transmitter with PD module. Hall Technologies June 8, 2022 Page 4 of 14... -
Page 5: Package Contents
Ÿ 1 x DC 12V Power Adapter with US, UK, EU, AU Pins Ÿ 1 x Phoenix Male Connector (3.5mm, 3 Pins) Ÿ 2 x Mounting Brackets (with Screws) Ÿ 1 x User Manual Hall Technologies June 8, 2022 Page 5 of 14... -
Page 6: Specifications
±8kV (Air-gap discharge)/ ±4kV (Contact discharge) Power Supply DC 12V 3A Power Consumption (Max) 8W (Without USB) Device Dimension 210mm x 25mm x 90.2mm/8.27” x 0.98” x 3.55” (W x H x D) Hall Technologies June 8, 2022 Page 6 of 14... -
Page 7: Panel Description
On: HDCP protected content is being transmitted. HDCP LED Blinking: Non-HDCP protected content is being transmitted. Off: No content is being transmitted. On: HDBT link is normal. LINK LED Blinking/Off: Link error or no link. Hall Technologies June 8, 2022 Page 7 of 14... -
Page 8: Rear Panel
Connect to an HDMI display. Unbalanced stereo audio output. • PASS-THROUGH: For audio pass-through from Audio IN AUDIO OUT port on the transmitter to this port. • DE-EMBED: For audio de-embedding from the HDMI output. Hall Technologies June 8, 2022 Page 8 of 14... -
Page 9: Installation And Wiring
3. Repeat steps from 1 to 2 for the other side of the unit. 4. Attach the brackets to the surface you want to hold the unit against using the screws (provided by others). Hall Technologies June 8, 2022 Page 9 of 14... -
Page 10: Wiring
PD module. 6. Connect video and audio sources to the wall-plate HDBT transmitter. 7. Connect a USB Host device to USB port of the transmitter. 8. Power on all devices. Hall Technologies June 8, 2022 Page 10 of 14... - Page 11 DSCV-70-RX Hall Technologies June 8, 2022 Page 11 of 14...
-
Page 12: Rs232 Operation
5. When all is set, serial commands can be preset to the transmitter through the connected PC, and the transmitter can send the preset commands to the connected projector of the receiver to control it. Hall Technologies June 8, 2022 Page 12 of 14... -
Page 13: Control The Wall Plate Transmitter
3. Connect HDBT IN of the receiver to HDBT OUT of the wall plate transmitter. 4. When all settings are completed, serial commands can be transmitted between the control system and the transmitter for controlling and configuring the transmitter. Hall Technologies June 8, 2022 Page 13 of 14... - Page 14 © Copyright 2022. Hall Technologies All rights reserved. 1234 Lakeshore Drive, Coppell, TX 75019 halltechav.com / support@halltechav.com (714)641-6607 Hall Technologies June 8, 2022 Page 14 of 14...