DeWalt DCE088G18 Manual page 17

Accessories
The laser is equipped with both 1/4 - 20 and 5/8 - 11
female threads on the bottom of the unit (Figure
This thread is to accommodate current or future
D WALT accessories. Only use D
E
specified for use with this product. Follow the
directions included with the accessory.
WARNING:
Since accessories, other than those
offered by D WALT, have not been tested with
e
this product, use of such accessories with
this tool could be hazardous. To reduce the
risk of injury, only D
accessories should be used with this product.
If you need any assistance in locating any accessory,
please contact your nearest D
go to www.2helpU.com.
Target Card
Some laser kits include a Laser Target Card
(Figure ) to aid in locating and marking the laser
L
beam. The target card enhances the visibility of the
laser beam as the beam crosses over the card. The
card is marked with standard and metric scales. The
laser beam passes through the red plastic and reflects
off of the reflective tape on the reverse side. The
magnet at the top of the card is designed to hold the
target card to ceiling track or steel studs to determine
plumb and level positions. For best performance when
using the Target Card, the D
facing you.
Laser Enhancement Glasses
Some laser kits include Laser En hancement Glasses
(Figure ). These glasses improve the visibility of
M
the laser beam under bright light conditions or over
long distances when the laser is used for interior
applications. These glasses are not required to operate
the laser.
).
J
WALT accessories
E
WALT recommended
E
WALT service center or
E
WALT logo should be
e
CAUTION:
These glasses are not ANSI
approved safety glasses and should not
be used while operating other tools. These
glasses do not keep the laser beam from
entering your eyes.
CAUTION:
To reduce the risk of serious injury,
never stare directly into the laser beam with or
without these glasses.
Ceiling Mount
The laser ceiling mount (Figure
more mounting options for the laser. The ceiling mount
has a clamp (Figure ) at one end which can be
K 2
fixed to a wall angle for acoustic ceiling installation
(Figure ). At each end of the ceiling mount is a
K 3
screw hole (Figure and
K 4
mount to be attached to any surface with a nail or screw.
Once the ceiling mount is secured, its steel plate
provides a surface to which the magnetic pivot bracket
(Figure ) can be attached. The position of the
K 6
laser can then be fine-tuned by sliding the magnetic
pivot bracket up or down on the wall mount.
Service and Repairs
NOTE: Disassembling the laser level(s) will void
all warranties on the product.
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
authorized service centers. Service or maintenance
performed by unqualified personnel may result in a
risk of injury. To locate your nearest D
center go to www.2helpU.com.
Warranty
Go to www.2helpU.com for the latest
warranty information.
), if included, offers
K 1
), allowing the ceiling
K 5
WALT service
E
17
GB