Sunnydaze Decor 132830001 Assembly Instruction

Please read the assembly and operating instructions carefully and observe the safety

instructions. Keep these details in a safe place for future reference.

ASSEMBLY

* Assemble components as per the diagram below on a smooth surface to avoid scratching

* Connect built-in tubing to the pump (1)

* Run the pump power cord through the groove in the back of the fountain (2)

* Fill the feature with sufficient water to fully submerse the pump

* Connect the plug to an electrical outlet (3)

* Adjust the pump for the water flower effect

* If in doubt about any electrical connections please consult a qualified electrician

* Fill the fountain with sufficient water to ensure the pump is well submersed

* Clean and top-up the water on a regular basis

* Always shut off the power before cleaning and maintaining the pump

* Never allow the fountain pump to run dry as this will cause damage and invalidate the warranty

* During winter never allow ice to form in the bowls as the force of the ice forming will crack the bowls. Drain the fountain and

store indoors.

* The pump should be disconnected from the main power supply, removed from the fountain and cleaned in the following way:

(a) remove the inlet cover from the front of the pump and gently grip the impeller to pull out the rotor assembly from the pump

(b) clean the rotor and rotor housing with water then dry with kitchen paper

Thank you for choosing Sunnydaze Décor. If you have any questions, comments or concerns

please feel free to contact us by phone at: 888-881-4668, by email:

customerservice@serenityhealth.com, or you could also email us via our contact us page at:

www.SerenityHealth.com/contact-us/

We stand behind our brand and the quality of the items we sell. We will send new parts, or

replace products at our discretion within the one year warranty period. Before we can help, you

will need to provide proof of purchase with the date of purchase and photos of the defective

merchandise. We will use the photos to determine the cause of defect and for future quality

control.

132830001 / Assembly Instruction

Table of Contents

Do you have a question about the 132830001 and is the answer not in the manual?

Page 1 We will use the photos to determine the cause of defect and for future quality control. 132830001 / Assembly Instruction Please read the assembly and operating instructions carefully and observe the safety instructions. Keep these details in a safe place for future reference.
Page 2 TROUBLESHOOTING If the water pump fails to operate, check the following: 1. If the pump cannot pump water check if the power is correctly connected or check if sufficient water is inside the reservoir. (a) Check the pump and tubing for any form of obstructions. (b) Remove the cover with the pump flow adjuster on it and gently lever off the inner cover to reveal the pump impeller and gently turn the rotor to check that it is not broken or jammed.