Loading An Application; Removing An Application - Zener 8000 Application Manual

Application SW08024: PID Irrigator

Loading an Application:

ESC
A00 DEFAULTS
Application
<NONE>
OR
PID Irrigator
Config (default)
To load the application:
Application
<NONE>

Removing an Application:

Factory defaults must be restored to prepare
the ZENER 8000 for application loading. To
restore defaults follow the procedure below.
ESC
PID Irrigator
a
User Menu
A00 DEFAULTS
a
Load factory
defaults?
CONTINUE WITH
FACTORY DEFAULTS
Page 7 Document: IM00160A
ENTER
&
DOWN
ENTER
PRESS
Application
PID Irrigator
▼
DOWN
ENTER
ENTER
ENTER
Load Complete ?
15/07/19
Loading an Application will program the drive for you
and create a unique menu with the parameters you
need to adjust.
If 'APPLICATION <NONE>' is displayed this means there
is no Application loaded.
If 'APP: PID Irrigator' is displayed this means this an
application has been loaded. The application will be
displayed.
To remove an unwanted application, see the section
"Removing an Application" below.
This should be performed in LOCAL MODE as
the pump may run. (Remove link in terminal 5)
▼
DOWN TO FIND THE DESIRED APPLICATION
ENTER TO SELECT & LOAD
This will take you direct to the 'CONFIG MENU'.
Go to page 9
NOTE:
To restore defaults the ZENER 8000 must not be
in REMOTE mode. Remove terminal 5.
CAUTION MAY START WITHOUT
NOTICE CHECK WIRING. CONTINUE ?
Press ESC and ENTER to SAVE CHANGES when prompted.
Power Down the ZENER 8000 completely and then
REPEAT the procedure to load the application.