Table of Contents
Advertisement
Fasten both plates by means of hex, head screws
(install flat washers).
Torque limit
(M8/8.8)
23 Nm
NOTE :
Secure hex. head screws with Loctite (Type-No.
270).
Figure 100
Squeeze in circlip 8.
( S ) Clamping pliers
5870 900 021
Press the speedometer-drive worm against shoulder.
NOTE :
Figure 101
In
case
of
a
Version
without
mechanical
speedometer, a spacer has to be installed instead of
the speedometer-drive worm !
Thread up output shaft 9 until contact is obtained.
Figure 102
\
Figure 103
SPC000007
Transmission and Torque Converter
Page 108
Advertisement
Chapters
Table of Contents
