Doosan DISD SD 310 Shop Manual page 117

(1) Rotate the crankshaft to overlap the intake and the exhaust valves of #6, then #1 cylinder become the
compression state of top dead center.
(2) Therefore adjust the valve clearance corresponding to ―
At this time there are no force on the push rods of #1 cylinder.
(3) Rotating the crankshaft by one revolution, #6 cylinder become the compression state of top dead
center.
(4) Thereafter adjust the valve clearances corresponding to ―
(5) After reinsuring the valve clearances, retighten if necessary.
²No. 1 cylinder is located at the side where flywheel was installed.
2.1.9 Cylinder compression pressure
²Stop the engine after warming up, and take out nozzle
holder assembly.
5ton Diesel Engine
―of lower figure.
―of lower figure.
SPC000006
Page 17