Table of Contents
Advertisement
OPERATION
1.
Connect the appliance to a wall outlet and switch on. The unit will beep and the
display will read "OFF".
2.
Select the desired cooking function (Both Grill / Upper Grill / Lower Grill) by
pressing the corresponding button.
3.
Turn the knob to adjust temperature. After setting temperature, press the knob in.
The time on the display will flash, turn the knob to adjust the time.
4.
Press the "Start" button to begin preheating. When the unit starts preheating, the
display shows "PRE" and the setting temperature. When the preheating process is
complete, the unit beeps 5 times, the temperature and time flash on display to
remind preheating finished;
5.
For better results, add a little cooking oil or a small quantity of the ingredients to
the plate. Put the food on the grill plate and press the "Start" button. The unit
starts counting down.
Note:
If "Start" button is not pressed within 30 minutes, the unit will go into standby mode.
6.
When the countdown is over, the unit will beep 5 times and the display will show
"done".
7.
Press "Cancel" button to go into standby mode, the display will show "OFF".
8.
Use the handle to lift the lid. Remove the food with a heat-resistant plastic
spatula. Never use sharp mental tongs or a knife as these can cause damage to
the non-stick coating of the grill plates.
Advertisement
Table of Contents
