Creating A Numerical Table From Two Functions (Table) - Casio fx-82ZA PLUS II User Manual

Creating a Numerical Table from Two
Functions (TABLE)
TABLE generates a numerical table based on one or two functions. You
can use the function f(x) or the two functions f(x) and g(x). See
"Configuring the Calculator Setup" for more information.
Perform the following steps to generate a numerical table.
1. Press (TABLE) to enter the TABLE Mode.
2. Use the X variable to input two functions, one in the format f(x) and the
other in the format g(x).
• Be sure to input the X variable (
numerical table. Any variable other than X is handled as a constant.
• If you are using a single function, input a function in the format f(x)
only.
• The following cannot be used in the function: Pol, Rec.
3. In response to the prompts that appear, input the values you want to
use, pressing
For this prompt:
Start?
End?
after each one.
Input this:
Input the lower limit of X (Default = 1).
Input the upper limit of X (Default =
5).
Note: Make sure that the End value is
always greater than the Start value.
44
(X)) when generating a