Creating A Number Table From Two Functions (Table) - Casio fx-991ZA Plus User Manual

9 9
Determine the MatA=
A!4(MATRIX)c1(Ref) MatA)=
Determine the MatA=
10 10
A!4(MATRIX)c2(Rref) MatA)=
Creating a Number Table from Two
Functions (TABLE)
TABLE generates a number table based on one or two functions. You can
use the function
Calculator Setup" for more information.
Perform the following steps to generate a number table.
1. Press N7(TABLE) to enter the TABLE Mode.
2. Use the X variable to input two functions, one in the format
other in the format
• Be sure to input the X variable (S)(X)) when generating a number
table. Any variable other than X is handled as a constant.
• If you are using a single function, input a function in the format
only.
• The following cannot be used in the function: Pol, Rec, ∫,
3. In response to the prompts that appear, input the values you want to use,
pressing = after each one.
For this prompt: Input this:
Start?
End?
Step?
• Inputting the Step value and pressing = generates and displays the
number table in accordance with the parameters you specified.
• Pressing A while the number table screen is displayed will return to
the function input screen in step 2.
f x
( ) or the two functions
g x
( ).
Input the lower limit of X (Default = 1).
Input the upper limit of X (Default = 5).
Note: Make sure that the End value is always
greater than the Start value.
Input the increment step (Default = 1).
Note: The Step specifies by how much the Start
value should be sequentially incremented as the
number table is generated. If you specify Start = 1
and Step = 1, X sequentially will be assigned the
values 1, 2, 3, 4, and so on to generate the number
table until the End value is reached.
row echelon form.
reduced row echelon form.
f x
( ) and
EN-35
g x
( ). See "Configuring the
f
d/dx
x
( ) and the
f x
( )
, Σ.