AIR-EAGLE
900MHz RF Receiver
MODEL 461-20800-AC
DESCRIPTION
The A
-E
XLT P
is an RF system designed for long range
IR
AGLE
LUS
wireless remote control of electrical apparatus in a variety of industrial
applications. Systems can consist of any number of transmitters and
receivers working together. This receiver is equipped with 8 independent
relays that can switch 5 amps @ 120VAC or 30VDC and can be directly
interfaced with the customer's equipment or P.L.C. Eight user selectable
frequencies allow multiple systems to be used in the same area. The Air-
Eagle XLT Plus can receive remote signals transmitted from up to 5000
feet away (with a handheld transmitter) or up to 10 miles away (with a
stationary transmitter and external antennas)..
SERIES FEATURE
The "461" series features built-in repeating capability. Each receiver
accepts and performs commands from the transmitter then repeats the
commands to any other receiver within its range. When using multiple
receivers this increases range and reliability because if there is a receiver
that the transmitter can't quite reach but is within range of another receiver
that HAS gotten the signal, it will still get its command from that receiver.
INSTALLATION
DISCONNECT AC Power from all equipment before installation.
1.
Mount the A
-E
XLT PLUS R
IR
AGLE
2.
Install relay wiring to terminal strip.
3.
Install antenna onto antenna connector located on the right side on
the enclosure.
4.
Connect supplied power input cable to your external power source.
TERMINAL STRIP WIRING
1
N/O Relay #1
10 N/O Relay #4
2
C Relay #1
11 C Relay #4
3
N/C Relay #1
12 N/C Relay #4
4
N/O Relay #2
13 N/O Relay #5
5
C Relay #2
14 C Relay #5
6
N/C Relay #2
15 N/C Relay #5
7
N/O Relay #3
16 N/O Relay #6
8
C Relay #3
17 C Relay #6
9
N/C Relay #3
18 N/C Relay #6
AC POWER INPUT
Terminal #1
Terminal #2
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT PLUS
in a convenient location.
ECEIVER
19 N/O Relay #7
20 C Relay #7
21 N/C Relay #7
22 N/O Relay #8
23 C Relay #8
24 N/C Relay #8
100-250 VAC
100-250 VAC
PRODUCT INFORMATION
BULLETIN
DC powered unit pictured
CONTROLS & INDICATORS
Dual color LED. Illuminates red while receiver is
booting up; changes to green when boot-up is
POWER LED
successful and unit is ready to operate. If this LED
(LED1)
fails to turn green, power unit off for 15-20 seconds,
then reapply power.
Illuminated green while relay is energized
RELAY LEDS
DIP SWITCHES
Switches used to set user-selectable options and/or
network frequency
(SEL1)
Socket mounted integrated circuit that holds unit's
EEPROM CHIP
program
(IC1)
RF MODULE
RF Module that sends/receives data from our
transmitters/receivers
(RF2)