BWI Eagle AIR-EAGLE XLT PLUS Product Information Bulletin

AIR-EAGLE
High Power 900MHz RF Repeater
MODEL 461-4500-AC
DESCRIPTION
The A -E XLT PLUS RF R
IR AGLE
RF signal from any Air-Eagle XLT PLUS Transmitter. When placed in
an area where the signal is weak, this unit will then re-transmit at full
strength facilitating greater distances and allowing the RF signal to
reach around corners, through tunnels, over hills and through valleys.
APPROVALS
United States (FCC)
Canada (IC)
INSTALLATION
DISCONNECT Power from all equipment before installation.
Mount the A -E XLT PLUS REPEATER in a convenient
IR AGLE
1.
location.
2. Attach rubber duck antenna or coax from external antenna to
connector on side of enclosure.
3. Connect supplied power input to your external power source.
TERMINAL STRIP WIRING
TERMINAL STRIP WIRING (TER1)
100-250 VAC Power Input
Terminal 1
Terminal 2 100-250 VAC Power Input
Terminal 3 Not Used
Terminal 4 Not Used
Terminal 5 Not Used
Terminal 6 Not Used
Terminal 7 Not Used
Terminal 8 Not Used
Terminal 9 Not Used
Terminal 10 Not Used
Terminal 11 Not Used
Terminal 12 Not Used
Terminal 13 Not Used
Terminal 14 Not Used
Terminal 15 Not Used
Terminal 16 Not Used
Terminal 17 Not Used
Terminal 18 Not Used
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT PLUS
designed to retransmit an
EPEATER IS
MCQ-XBPSX
1846A-XBPSX
PRODUCT INFORMATION
BULLETIN
CONTROLS & INDICATORS
RX LED
POWER LED
TX LED
RF1
SEL1
Yellow LED illuminates as remote signals are
being received by the repeater
Green LED is illuminated while power is
applied to the repeater
Red LED illuminates as remote signals are
being re-transmitted by the repeater
RF module that receives data from the remote
transmitter
Used to set frequency