461P-HH-4-003-CL WARRANTY STATEMENT BWI Eagle Inc. warrants the Air-Eagle Remote Control System, if properly used and installed, will be free from defects in material and workmanship for a period of 1 year after date of purchase. Said warranty to include the repair or replacement of defective equipment. This warranty does not cover damage due to external causes, including accident, problems with electrical power, usage not in accordance with product instructions, misuse, neglect, alteration, repair, improper installation, or improper testing.
Page 3
461P-HH-4-003-CL INTRODUCTION The Air-Eagle XLT Plus is an RF system designed for extra-long range wireless remote control of electrical apparatus in a variety of industrial applications. Systems can consist of any number of receivers and handheld or contact input transmitters working together to create an extra-long-range radio frequency system that operates hazardous or hard-to-reach equipment from safe, convenient locations.
461P-HH-4-003-CL CONTROLS & INDICATORS LED illuminates continuously while button is pressed and unit is TX LED transmitting. When this LED blinks briefly following a transmission, the battery needs to be replaced. * Pushbuttons 1-4 Transmits an individual RF code to the receiver. *Note: The low battery notification signals have been improved to provide more noticeable indications and to safely disable communications BEFORE a low battery condition can corrupt internal memory causing device failure.
461P-HH-4-003-CL FREQUENCY PROGRAMMING Read instructions completely before beginning programming procedure. Transmitters are shipped from the factory set to Frequency 1 by default. The frequency can be changed at any time by following the procedure below. Once changed, it is recommended to label the transmitter with the selected frequency number.
Page 6
461P-HH-4-003-CL FREQUENCY PROGRAMMING (Continued) To Select Frequency 5 - 8: 1. Press Buttons 3 & 4 simultaneously for approximately 7 seconds until the TX LED illuminates GREEN. 2. Release Buttons 3 & 4. While TX LED is still GREEN press Button 1 to select Frequency 5, Button 2 to select Frequency 6, etc.