HP z560 Setup Manual page 30

Connect another Video Out
To temporarily change Video Out such as HDMI or VGA video (any output other than component video):
1 Turn off the TV/display.
2 Turn off the HP Digital Entertainment Center by pressing and holding the On/Standby power button for 4
seconds. The On/Standby button should be dark and not lit amber or blue.
3 Disconnect the component video cable from the HP Digital Entertainment Center back-panel Video Out.
4 Connect another Video Out, such as HDMI or VGA video cables to the HP Digital Entertainment Center
back-panel Video Out.
NOTE: If your TV/display can accept HDMI or VGA video, connect HDMI or VGA video, for a
higher-quality image.
5 Turn on the TV/display.
6 Switch the TV/display input to the HDMI or VGA video input.
7 Turn on the HP Digital Entertainment Center by pressing the On/Standby power button.
a Wait 1 to 2 minutes. The video image reappears.
b Do not restart your HP Digital Entertainment Center.
26
HP Digital Entertainment Center TV/Display Setup Guide