Troubleshooting Component Video; Check Component Video - HP z560 Setup Manual

Digital entertainment center tv/display setup guide
Hide thumbs Also See for z560:
Table of Contents

Advertisement

7 Test the keyboard. If it still doesn't work:
Check the batteries for correct installation.
Remove interference sources that may interfere with transmission such as 49 MHz cordless phones,
49 MHz toy remote controls, or metal shelves or furniture.
Move the HP Digital Entertainment Center to another location and retest.
8 Clean the trackball. Refer to the instructions in the Getting Started Guide.

Troubleshooting Component Video

This section contains important information about correcting problems that you may encounter with your
HP Digital Entertainment Center Component Video Setup.
The component video connections are the green, blue, and red connectors, labeled Y, Pb, Pr, on
your HP Digital Entertainment Center back panel. These three connectors combine to form a
quality Video Out. (They do not transfer audio.) There are several types of Component Video Outs. The
HP Digital Entertainment Center supports YPbPr Component Video Out only.
Component Video Out requires specific configurations for certain display types and resolutions. You can adjust
the display for component video using:
The display wizard. See "TV/Display Setup Wizard" on page 5.
Or
See "HDTV Overscan Compensation" on page 10.

Check component video

To check component video before you begin:
1 Turn off the TV/display.
2 Turn off the HP Digital Entertainment Center by pressing and holding the On/Standby power button for 4
seconds. The On/Standby button should be dark and not lit amber or blue.
3 Check the cables. Make sure that they are completely plugged in and that the green, blue, and red colors
match on both ends.
Green: Y, Blue: Pb, Red: Pr
4 Remove all other video out cables from the HP Digital Entertainment Center back panel.
5 Turn on the TV/display.
6 Check the TV/display input switch. For example "Component 1."
7 Turn on the HP Digital Entertainment Center by pressing the On/Standby power button. Wait 1 to 2 minutes.
The video image should reappear.
HP Digital Entertainment Center TV/Display Setup Guide
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z558 entertainment

Table of Contents