Candy CHK46C Instruction Manual page 5

Installation
Electrical connection
Before connecting the appliance, make sure that the supply voltage
marked on the Rating Plate corresponds with your mains supply voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
⚫ If you have to change the oven power cord, the earthing (yellow/green) conductor
must always be 10 mm longer than the line conductors.
⚫ Care must be taken to ensure that the temperature of the mains supply cable does
not exceed 50°C.
⚫ If the mains supply cable is damaged, then it must be replaced by an appropriate
replacement which can be obtained from Spares Department.
Assembly of ceramic hob :
Preparing the unit for a built-in appliance
WARNING
The kitchen units that are in direct contact with the appliances must be heat-
proof(min. 95°).
The appliance can be installed on a work surface with a thickness of between 30
and 40 mm and near to walls which are higher than the work surface,maintaining a
minimum distance of 100 mm.
Carry out all cutting of the unit and work surface then carefully remove shavings or
sawdust before inserting the appliances.
To ensure a correct ventilation of the hob please comply with the dimensions
shows in figures .
5